Chapter 2: Local Management
2-12
WPIM-DI Local Management Guide
The line configuration information shown in Table 2-1 must be supplied
by the service provider.
2.3.1
WPIM-DI Physical Configuration
Begin the WPIM-DI configuration by accessing the WAN Physical
Configuration screen (Figure 2-1) through Local Management. To access
the WAN Physical Configuration screen from the Setup Menu screen, use
the arrow keys to highlight the WAN Setup option, then press ENTER.
The screen shown in Figure 2-1 appears. Proceed with the following
steps:
1. Use the arrow keys to highlight the [WPIM] field at the bottom of the
screen. Press the SPACE bar to select the WPIM being configured,
then press ENTER.
2. Use the arrow keys to highlight NI/DI Timeslot View. Press the
SPACE bar to select New, then press ENTER. The cursor moves to
Timeslot #1 of the Timeslot Configuration table.
3. Insert an interface number (refer to the NOTE below) into every
Timeslot. Type the number, press ENTER, then use the arrow keys to
highlight the next Timeslot field. Exit this field by using the arrow
keys. The cursor automatically moves to the NI/DI Line Coding field.
Table 2-1
Telco Configuration Information
Configuration Information
Required by User
Configuration Information
Supplied by Service Provider
Line Coding
B8ZS or AMI
Frame Type
ESF or D4
Clock Source
Loop Timing or Local Timing
DS0 (Timeslots)
Timeslots being used for each end of
the circuit
