INSTALLING THE TPT
3-6
10BASE-T
TPT
Device Tranceiver
RX+
TX+
RX-
TX-
TX+
RX+
TX-
RX+
Figure 3-1
Twisted Pair Connection
To connect the TPT to your network (Fig. 3-3)
1.
Connect the twisted pair segment to the TPT by
inserting the RJ-45 connector on the segment into the
RJ-45 port on the transceiver.
2.
Verify that the LNK LED on the transceiver is lit. If the
LED is not lit, perform each of the following steps
until it is lit:
•
Disconnect the RJ-45 connector from the RJ-45
port of the transceiver.
•
Verify that the RJ-45 connector on the twisted pair
segment has the proper pin outs.
•
Check the cable for continuity.
Summary of Contents for TPT
Page 2: ......
