Cabletron Systems SmartSwitch 8-slot, User'S Reference Manual

Page: 26 / 150

Chapter 1: SmartSwitch Router Product Overview
1 - 8 SSR User Reference Manual
bgp - Configure Border Gateway Protocol (BGP)
cli - Modify the command line interface behavior
dvmrp - Configure DVMRP related parameters
exit - Exit current mode
filters - Configure L2 security filters
http - Configure SNMP related parameters.
igmp - Configure IGMP related parameters
interface - Configure interface related parameters
ip - Configure IP related parameters
ip-router - Configure Unicast Routing Protocol related
parameters
ipx - Configure IPX related parameters
ospf - Configure Open Shortest Path Protocol (OSPF)
port - Configure Port parameters
qos - Configure Quality of Service parameters
rip - Configure Routing Information Protocol (RIP)
snmp - Configure SNMP related parameters.
stp - Configure STP parameters
system - Configure system-wide parameters
tacacs - Configure TACACS related parameters
vlan - Configure VLAN-related parameters
Special configuration mode commands:
erase
- Erase configuration information
negate - Negate a command or a group of commands
using line numbers
no - Negate matching commands
save - Save configuration information
search - Look up a command in configuration
show - Show configuration commands
To exit Configure mode and return to Enable mode, use one of the following
commands:
Boot PROM Mode
If your SSR does not find a valid system image on the external PCMCIA flash, the
system might enter programmable read-only memory (PROM) mode. You should then
reboot the SSR at the boot PROM to restart the system. If the system fails to reboot
successfully, please call Cabletron Systems Technical Support to resolve the problem.
To reboot the SSR from the ROM monitor mode, enter the following command.
Exit Configure mode.
exit
Ctrl-Z
Reboot in Boot PROM mode. reboot