Cabletron Systems SmartSwitch 8-slot, User'S Reference Manual

Page: 23 / 150

Chapter 1: SmartSwitch Router Product Overview
SSR User Reference Manual 1 - 5
Note: The command prompt will show the name of the SmartSwitch Router in
front of the mode character(s). The default name is “ssr”.
When you are in Configure or Enable mode, use the
exit
command or press Ctrl-z to
exit to the previous access mode.
Note:
When you exit Configure mode, the CLI will ask you whether you want to
activate the configuration commands you have issued. If you enter
Y
(Yes),
the configuration commands you issued are placed into effect and the
SmartSwitch Router’s configuration is changed accordingly. However, the
changes are not written to the Startup configuration file in the Control Mod-
ule’s boot flash and therefore are not reinstated after a reboot.
User Mode
After you log in to the SSR, you are automatically in User mode. The User commands
available are a subset of those available in Enable mode. In general, the User
commands allow you to display basic information and use basic utilities such as ping
information.
To list the User commands, enter:
The User mode command prompt consists of the SSR name followed by the angle
bracket (>):
ssr>
The default name is SSR unless it has been changed during initial configuration using
the system set name command. Refer to the SmartSwitch Router Command Line
Interface Reference Manual for information on the system facility.
To list the commands available in User mode, enter a question mark (?) as shown in
the following example:
ssr> ?
aging
- Show L2 and L3 Aging information
cli - Modify the command line interface behavior
dvmrp - Show DVMRP related parameters
enable - Enable privileged user mode
exit - Exit current mode
file - File manipulation commands
igmp - Show IGMP related parameters
ipx - Show IPX related parameters
List the User commands.
?