MMAC-M5FNB SETUP
Page 3-8
Install the M5PSM(s) into your MMAC-M5FNB as follows:
1.
Unpack the M5PSM by removing it from the shipping box and
sliding the two foam end caps off the unit. Save the shipping box
and materials in the event the unit must be reshipped.
2.
Remove the M5PSM from its protective plastic bag.
3.
For the optional redundant power supply module, loosen the
knurled knobs securing the panels over the leftmost M5PSM
opening in your MMAC-M5FNB and remove the panels. Keep the
panels in case you need to remove the M5PSM. (Note: There are no
panels over the rightmost M5PSM opening.)
4.
Slide the M5PSM into the appropriate slot of the MMAC-M5FNB
(Figure 3-5) as follows:
a.
Hold the module by placing one hand on the handle located on
the front panel and using the other hand to support the body of
the module.
b.
With the LEDs at the top of the M5PSM, align the M5PSM
with the slotted paths on the top and bottom of the opening.
c.
Ensuring that the power supply is inserted into the slotted
paths, carefully slide the module forward until the module is
connected to the backplane and its front panel is flush with the
face of the MMAC-M5FNB. Do not force the module into place.
If you encounter significant resistance before the front panel is
flush, remove and reinsert it.
