Cabletron Systems MicroMMAC 22ES, Installation Manual

Page: 80 / 93

Appendix C: Flash Upgrade Instructions
C-2 Micro-CS Installation Guide
C.4 INSTALLATION PROCEDURE
C.4.1 Installing the Flash Daughter Card
1. Install the two (2) snap-in nylon standoffs through the holes in each
corner of the flash daughter card.
2. Align the connector of the flash daughter card with the J12 connector
on the Micro-CS (see Figure C-1) and seat firmly ensuring that the
nylon standoffs snap into their mating holes on the board.
Figure C-1 Flash Card Installation
Please note that although the hardware configuration of the FLASH card
is the same for the Micro-CS, CSMIM2, and MODMIM, the image is not.
The Micro-CS uses “oper.52.enet” and the CSMIM2/MODMIM use
“oper.42.enet”. It is possible to use the FLASH card on either platform,
but the image loaded must be the correct one for the application.
!
CAUTION
Observe all anti-static procedures when handling electronic
equipment.
J12
FLASH CARD
Nylon standoffs
Snap In Retainer