Configuration Commands
80-10100000-09
4–39
1> SET ADDRESS XXXXX
[CR]
where
xxxxx
is from 1 to 5 alphanumeric characters.
To display the sub-address number that has been set type:
1> ADDRESS
[CR]
To remove the sub-address number, type:
1> SET ADDRESS
[CR]
4.20 Password Protection
Password Protection has been implemented in this version of software.
Typing:
1> PASSWORD
[CR]
displays whether password protection is enabled or not (it is normally
disabled.)
4.20.1 Setting and Entering the Password
To enable password protection, type:
1> SET PASSWORD
[CR]
The response to this is
Enter Password:
You must then enter your password which must be from 5 to 20
alphanumeric characters, followed by a [CR]. Each character entered is
echoed by a * on the command line.
The response to this is then;
Re-enter password for confirmation:
When you must re-enter the same password.
If this is successful the response is
Password accepted