KBU 64
User Manual
80-10100000-09
4–26
1> SET CONNECT xx
[CR]
where
xx
is AUTO or MAN
When set to MAN (this is the factory default/normal state), Talkwire
commands control the connection. During an automatic backup call, the
remote unit will receive a connect command from the unit that is
performing the backup. The TALKWIRE parameter must therefore be set
to ON.
CONNECT should only set to AUTO in applications where the calling
device is not a KBU 64 and therefore cannot respond to talkwire
commands– contact your Technical Support for further information.
4.13.7 Disconnecting Data Transfer From the ISDN Line
When Talkwire is used (which is the normal use), the Talkwire
commands control disconnection of the USER port from the ISDN. The
DISCONNECT parameter must be set to MANual.
1> SET DISCONNECT xx
[CR]
where
xx
is
AUTO
or
MAN
When set to MAN (factory default/normal) Talkwire commands control
the disconnection, and the TALKWIRE parameter must be set to ON.
DISCONNECT should only be set to AUTO in special applications –
contact your Technical Support for further information.
Normally therefore, the DISCONNECT parameter should be set to MAN
and the TALKWIRE parameter set to ON.
4.13.8 Restoring a Call to the Kilostream Link From the
ISDN Line
AUTO parameter
