KBU 64
User Manual
80-10100000-09
6–4
6.5 Connecting the USER Port to the ISDN Line
Following DIAL or ANSWER commands, the CONNECT command is
used to interrupt the Kilostream data path and re-direct data down the
ISDN link, if the ISDN link is on-line.
1> CONNECT
[CR]
This command is not needed for either manual or automatic backup
calls.
6.6 Disconnecting the User Port from the ISDN Line
The DISCONNECT command is used to disconnect the USER port from
the ISDN channel and revert data transmission to the Kilostream line.
1> DISCONNECT
[CR]
Disconnecting the USER port from the ISDN link does not terminate the
ISDN call. This requires a separate HANGUP command (see section
6.7
) to be entered at the command line prompt before the ISDN call will be
dropped.
6.7 Hanging-up an ISDN Call
The HANGUP command must be used to terminate an ISDN call
following the DISCONNECT command.
1> HANGUP
[CR]
6.8 Manually Restoring Data Traffic to the
Kilostream Link
Issuing the RESTORE command disconnects the USER port from an
ISDN call, and reverts data down the Kilostream link. The ISDN call is
then automatically dropped.
1> RESTORE
[CR]
