Chapter 1: DIGITAL GIGAswitch/Router Product Overview
6
DIGITAL GIGAswitch/Router User Reference Manual
When you are in Configure or Enable mode, enter the
exit
command or press Ctrl+Z to
exit to the previous access mode.
Note:
When you exit Configure mode, the CLI will ask you whether you want to
activate the configuration commands you have issued. If you enter
Y
(Yes), the
configuration commands you issued are placed into effect and the DIGITAL
GIGAswitch/Router’s configuration is changed accordingly. However, the
changes are not written to the Startup configuration file in the Control Module’s
boot flash and, therefore, are not reinstated after a reboot.
User Mode
After you log in to the GSR, you are automatically in User mode. The User commands
available are a subset of those available in Enable mode. In general, the User commands
allow you to display basic information and use basic utilities such as ping information.
To list the User commands, enter:
The User mode command prompt consists of the GSR name followed by the angle bracket
(>):
The default name is GSR unless it has been changed during initial configuration using the
system set name command. Refer to the
DIGITAL GIGAswitch/Router Command Line
Interface Reference Manual
for information on the system facility.
List the User commands.
?
gs/r>
