SIMM Upgrades
ESX-1320/ESX-1380 Installation Guide
3-11
Installing the SDRAM or LDRAM SIMM
To install an SDRAM or LDRAM SIMM, refer to Figure 3-7 and proceed
as follows:
1. Remove the chassis cover as described in Section 3.2.
2. Locate the SDRAM or LDRAM SIMM slot as shown in Figure 3-4.
3. Insert the SIMM between the connector teeth in the SIMM slot.
4. Pivot the SIMM back until it locks into the clips in the SIMM slot, and
the SIMM holes fit over the SIMM slot posts. (See Figure 3-7.)
Figure 3-7
Installing an SDRAM or LDRAM SIMM
!
CAUTION
The internal components and boards associated with the ESX
are static sensitive devices. Use the antistatic wrist band and
observe standard antistatic safety procedures when the cover
is removed. Failure to do so could cause damage or severely
limit the life expectancy of the ESX.
SIMM
Connector Clip
Connector
Teeth
SIMM Slot
SIMM Hole
SIMM Slot
Post
1
2
1574-11
