Appendix C: CSMIM2-16UG/MOD4-UG Port Upgrade Instructions
C-14
CSMIM2 Installation Guide
4.
Set MODMIM to Setup mode by pressing the Setup switch on the
front panel. The S/U indicator should light.
5.
The MODMIM runs its ROM–resident power–up diagnostics:
•
All indicators light momentarily and then turn off.
•
The Traf indicator flashes to show that diagnostics are running.
•
If the diagnostics complete successfully, the Stat and Attn
indicators light. After about one minute, the ROM Monitor prompt
appears on the console terminal.
6.
Issue the config command to verify the new hardware and port
configuration.
7.
The console responds with the board configuration. Check the heading
“MODEM Config” to insure that the correct number of modem ports
were recognized (12).
8.
At the monitor prompt, execute the boot command.
NOTE
Press the Setup switch within 3 seconds of powering-up.
