6-6
CRBRIM-W/E
CHAPTER 6: Maintenance
Figure 6-3. Removing and Replacing the System (FLASH) SIMM
Using the system board orientation shown in Figure 6-3, position the new SIMM
so that the polarization notch is located at the right end of the SIMM socket.
5.
Insert the new SIMM by sliding the edge with the metal fingers into the
SIMM connector socket at a slight angle to the system socket. Gently rock the
SIMM back into place until the latch on either side snaps into place. Do not
use excessive force, or the connector could break.
CRBRIM-W/E Faceplate
System SIMM Socket
System (FLASH) SIMM
Polarization Notch
System SIMM Installed
Some Flash SIMMs have the components mounted on the rear
side; therefore, when inserting the SIMM, always use the
polarization notch as a reference and not the position of the
components on the SIMM.
NOTE
Summary of Contents for CRBRIM-W/E
Page 1: ...CRBRIM W E USER S GUIDE ...
