Page 6
Model 64/64x2 Instruction Manual
PREPARATION
UNPACKING
Upon unpacking the Model 64 from its shipping carton, inspect it for evidence of abuse during
shipment. If such is found, notify Cablescan and the carrier at once. Save the shipping carton
and packing materials for later use.
INITIAL HOOKUP
When shipped from the factory, the Model 64 is supplied with a external power pack for
operating at a specific voltage. The operating voltages and corresponding power pack labels are
as follows:
Operating
Power Pack Label
Voltage
Input Output
100 VAC
120 VAC
12.0 VDC
115 VAC
120 VAC
9.0 VDC
220 VAC
220 VAC
9.0 VDC
The power connection on the rear panel (Figure 1) is labeled 9VDC. Connect and apply power
as follows:
1.
Verify the power pack is labeled correctly for the intended operating voltage. See
table above.
2.
Plug the power pack into the AC power source.
3.
Make sure that the power ON/OFF switch on the rear panel is OFF, and then
connect the output plug from the power pack into the connector labeled 9VDC.
4.
Turn power ON/OFF switch to ON, and observe that a message is displayed. The
Model 64 is ready for use. (If nothing happens, check power source, power plug
connection, and the fuse on the rear panel.)
PROGRAM CARTRIDGE INSTALLATION
Each Program Cartridge (EEPROM)can store up to sixteen programs. A label on the outside
surface of the cartridge (Figure 3) contains blanks for entering program names and signature
codes according to their storage locations. This label is erasable so it can be updated each time a
change is made in cartridge contents.
CAUTION
Be sure to turn off the power before installing or
removing a Program Cartridge.
Summary of Contents for 64
