Model 64/64x2 Instruction Manual
Page 7
To install a Program Cartridge, proceed as follows:
1.
Turn power off (power ON/OFF switch on rear panel).
2.
Verify cartridge contents on label: locations may be empty, or contain program(s)
that may to be deleted or used (figure 3, below).
3.
Slide cartridge into the front slot and press it firmly against the internal connector.
4.
Turn power on.
5.
Scroll through the menu (using Up and Down arrows) until LOAD CARTRIDGE
is displayed, and then press MENU RUN.
6.
Scroll through the signature codes of the programs one at a time. Check the
signature code of each location against the code recorded on the corresponding
locations of the cartridge label. If no programs are present, "MEMORY IS
EMPTY" will be displayed.
Cablescan
PROGRAM CODE
1
2
3
4
5
6
USE ERASABLE MARKER
7
8
FOR RECORDING PROGRAM
TOP
NUMBERS. BE SURE TO
POWER OFF BEFORE
REMOVING
UPDATE OR VERIFY LABEL
PROGRAM CODE
AT EACH LOAD OR SAVE.
9
10
11
12
13
14
15
16
Figure 3. Program Cartridge Label Format
Summary of Contents for 64
