CAB THARO Apollo 1 Series, Operator'S Manual

Page: 82 / 139

82 cab - Produkttechnik GmbH & Co KG / Tharo Systems, Inc.
Code Printout Code Printout Code Printout Code Printout
DEC HEX DEC HEX DEC HEX DEC HEX
00 00 08 08 16 10 24 18
01 01 09 09 17 11 25 19
02 02 10 0A 18 12 26 1A
03 03 11 0B 19 13 27 1B
04 04 12 0C 20 14 28 1C
05 05 13 0D 21 15 29 1D
06 06 14 0E 22 16 30 1E
07 07 15 0F 23 17 31 1F
Table 12 Representation of the control characters in monitor mode
12 Monitor Mode/ ASCII Dump Mode
If programming directly, the monitor mode provides a method to print control
sequences which were received at the interface. The commands will be
printed in text format depending on the selected character set. Error messages
will be printed directly behind the fault, e.g. for unknown commands.
In monitor mode, the Apollo will not recognize gaps between labels nor control
the ribbon feed.
NOTICE !
The font used for printouts in monitor mode is suitable to send by
facsimile. For questions or future reference, print and retain one copy of
the label format for each label printed.
Start of Monitor Mode/ ASCII Dump Mode
To start the monitor mode, press the key while switching on the printer,
and keep it pressed down until the system test is completed. The display
shows "ASCII Dump Mode".
To cancel ASCII Dump mode, press the key.
In monitor mode, the print of data will be started after every four lines of data
received. Therefore, in some cases, the last lines of the label have to be
retrieved by pressing the key.
Representation of the Control Characters
The control characters (ASCII Code 00 ... 31) as shown in monitor mode
printouts are as follows.