CAB THARO Apollo 1 Series, Operator'S Manual

Page: 128 / 139

C-6 cab - Produkttechnik GmbH & Co KG / Tharo Systems, Inc.
Error message
Protocol error (*)
Read error
sRAM
malfunction
Structural err.
Unknown card
Voltage error
Write error
Write protected
Possible cause
Printer has received an unknown or
invalid command (display shows
command abbreviated)
The interfaces of computer and
printer are set differently
Refers to the optional memory card;
Read error when reading from the
card
Hardware error
Refers to the optional memory
card; Fault in file list
Refers to the optional memory
card;
Card not formatted, or
Card not supported by printer
Hardware error
Refers to the optional memory
card;
Hardware error
Refers to the optional memory
card;
Write protection is activated
Solution
Depending on the type of fault, the
command can be skipped by
pressing the key or the print
job has to be cancelled by pressing
the key.
Switch printer off. Correct the
interface setting in the printer setup.
(see Chapter 9)
There is no solution. Check the
battery. Reformat card. Copy
backup files onto the card.
Switch printer off and then on.
If error recurs
→
contact Service.
Data access is uncertain.
Format card.
Format card.
Use different type of card.
Switch printer off and then on.
If error recurs
→
contact Service.
Repeat the write process or format
the card.
Deactivate write protection.
Table C-3 Error messages (continuation)