16
16
5
Adjustments
5.1
Mechanical Adjustments
Perform the mechanical adjustments in two steps :
Roughly align the pad in all directions to avoid collisions of the pad with other parts when switching on the
compressed air.
Perform the fine adjustment with compressed air switched on to optimize the labelling process.
5.1.1 Moving the Pad
3
2
1
4
5
7
ca 2 mm
ca 2 mm
6
Fig. 16
Moving the pad assembly
Adjustment in print direction
1. Loosen screw (1).
2. Move cylinder assembly (4) with pad at the guide rail that the distance between edge of the pad (6) to the edge of
the dispense plate (7) of the printer is approximately 2 mm.
3. Tighten screws (1).
Height adjustment
wide settings are described in section 3.3 and are only necessary in case of changing the pad type.
Fine adjustments:
1. Loosen screw (3).
2. Turn setting screw (2).
- Clockwise will move the pad higher.
- Counterclockwise will move the pad lower.
3. Tighten screw (3).
Side adjustment
1. Loosen screw (3).
2. Move cylinder assembly (5) with pad at the bearing (4) so that the dispensed label is aligned centrally to the pad
respectively to the open holes in an universal pad.
3. Tighten screw (3).
i
Notice !
Check the adjustments with compressed air switched on
