16
17
5
Adjustments
5.1.2 Adjusting the Parallelism between Pad and Dispense Edge
2
1
3
4
5
Fig. 17
Adjustment of parallelism
1. Loosen knurled screw (1).
2. Press the applicator against the printer and adjust the angle between applicator and printer via the setting screw
(2).
3. Fix the applicator again via knurled screw (1) on the printer.
4. If necessary for fine adjustment loosen screw (3).
5. Turn the pad (4) with easily turning of the pad in a parallel position to the dispense edge (5).
6. Tighten screw (3) .
5.1.3 Aligning the Blow Tube
1
2
2
3
3
Fig. 18
Alignment of the blow tube
1. The blow tube (2) for the supporting air can be rotated around its axis. That way the direction of the supporting air
can be optimized.
1. Loosen screw (1).
2. Turn the blow tube (2) in that direction, that the air current supports the sucking of the label by the pad.
• For small labels direct the air current to the dispense edge (3) of the printer.
• For larger labels direct the air current away from the dispense edge (3) .
3. Tighten screw (1).
