22
23
6.5
Standard Operation
Check all external connections.
Load the material. Ensure that the locking system is locked
"Operator's Manual" of the printer.
Open the shutoff valve.
!
Attention!
Ensure that the pad is not covered by a label when switching on the printer-applicator system.
Otherwise the vacuum sensor may be calibrated faultily.
Switch on the printer.
i
Notice!
Befindet sich der Stempel im Moment des Zuschaltens der Druckluft und des Druckers nicht in der Grund-
position wird eine Fehlermeldung auf dem Display des Druckers ausgegeben.
Durch Drücken der Taste PAUSE am Drucker wird der Fehler quittiert und der Applikator bewegt sich in die
Grundposition.
Der Applikator ist betriebsbereit.
Press the
feed
key at the printer.
A synchronization feed is released. The processed labels have to be removed manually. After a few seconds the
printer carries out a short backfeed to position the front edge of the next label at the printing line.
i
Notice!
This synchronizing also has to be carried out when the print job has been interrupted with the cancel key.
Synchronizing is not necessary when the printhead was not lifted between print jobs. This also applies if the
printer was powered off between print jobs.
Start a print job
Start the labelling process via PLC interface.
Error messages during labelling process are shown in the display of the printer
"Error Messages".
6
Operation
