14
14
4
Configuration
4.1.3
Print Parameters
Start Offline menu.
Select
Setup > Print param.
.
Parameter
Meaning
Default
Heat level
The
Heat level
setting only affects the test printouts and print
jobs without heat level definition in the software.
Otherwise the heat level defined in the software is used.
0
Print speed
Basic print speed setting.
The print speed can be re-specified for each print job via software.
The basic setting is not changed by this.
The print speed setting also affects the test printouts.
50 mm/s
Transfer print
On
for thermal transfer printing: Sensor for monitoring the transfer
ribbon is activated.
Off
for thermal direct printing: Sensor for monitoring the transfer
ribbon is not activated.
The setting can be overwritten for each print job via software. The
basic setting is not changed by this.
On
Warn level
ribbon
Warning via the Ethernet interface by way of an SNMP message or
e-mail sent when the remaining diameter of the ribbon supply roll
undershoots the set value (32–74 mm).
Off
Label sensor
Method for detecting the starting end of the label.
Gap Sensor
: Detection using changes in the transparency
between the label and label gap.
Bottom-Reflect
: Detection using reflex marks on the bottom of
the medium.
Gap
Sensor
Extrapolate pos.
The positions of the labels which are between the label sensor and
the printhead are calculated from the first label recognized by the
sensor and the programmed label distance. That way those labels
can be printed.
off
Tear-off mode
Positioning the label medium for tearing off at the tear-off plate.
On
: Additional advancement of the label medium which positions
the label gap after the last printed label at the dispense plate.
Off
: Label advance stops once the last label has fully passed the
print line.
On
Backfeed
Method for backfeeding the label medium.
Backfeeding is necessary in the cutting mode since the front edge
of the next label has passed the print line when cutting a label.
always
: Backfeeding occurs independently of label contents.
smart
: Backfeeding only occurs when the next label is not yet fully
prepared cutting the current label. Otherwise, the printing of the
next label is started, interrupted and completed after cutting of the
first label without backfeeding.
smart
Single-Print
mode
Peel-off mode : Behavior after removing a label from the peel
position
On
: The next label will be printed and peeled-off after touching
Off
: The next label will be printed and peeled-off immediately
Off
Cut mode : Behavior between the cuts
On
: After cutting the next label will be printed and cut after touching
Off
: All labels will be printed and cut nonstop
If dispenser module or cutter are not installed, access
only with service key inserted
