Powering Up
Battery Installation
NOTE:
In addition to inserting batteries, the camera can also be powered by connecting the
enclosed USB cable to your computer.
Be aware that if you use the USB cable connection,
images taken will be deleted when the camera is disconnected from PC.
1. On the back of your camera, slide the compartment cover to open.
2.
Install 3-AAA alkaline batteries
(not included) into the battery compartment. See figure below.
3.
Make sure the battery polarities are correctly oriented. See figure below.
4. Close battery compartment cover.
CAUTION - To avoid battery leakage
•
Non-rechargeable batteries are not to be recharged
•
Be sure to insert batteries in correct orientation
•
Remove batteries from the camera before extended storage
•
Always remove old or dead batteries from the camera
•
Do not short-circuit the power supply terminals
•
Check that the contact surfaces are clean and bright before installing batteries
Battery Power Levels
If at anytime the frame counter information begins to flash in the LCD panel, the battery level is
low. Download your photos to the computer and replace the batteries immediately.
Turning camera ON / OFF
Press
Mode
button to power on the camera. Two short beeps will sound.
(High Resolution) will
appear momentarily before
(frame count) is shown on the LCD panel, indicating that a maximum
of 20 images can be taken with high resolution.
To power off the camera, press
Mode
button repeatedly until "oF" displays on the LCD panel. Then
press
Shutter
button.
Auto Off
The camera will automatically turn off in 30 seconds if no operation has been performed.
4
NOTE: If batteries
are removed from the camera before downloading images, all images will be lost.
