3
Setup and General Use
•
Connect the pressure gauge to the Argon
bottle. Make sure it is not leaking. Tighten
if necessary.
•
Connect the nitrogen hose from the Wine
Dispenser to gauge by setting the pipe
into the push fitting connector. Before
connecting, remove the clip and put it
back after the connection.
•
There are 2 pressure gauges on the unit.
The small one gives reading of the pressure in the bottle from 0 to 3625 psi
while the large one shows the pressure in the pipeline from 0 to 87 psi.
•
Usually, the Argon bottle volume may range from 330 to 440 lbs/cm2. The
pressure in the pipeline should be between 1.5 and a maximum of 6 psi.
Higher pressure may negatively affect the operation of the system.
What if
it does?
•
The pressure can be adjusted manually. Pull the pressure gauge plastic
cover forward. The pressure can be controlled by turning the plastic
surrounding of the large dial. The pressure increases by turning clockwise
and decreases by turning it anti clockwise. After setting the correct
pressure level the plastic cover can be pushed back again, this maintains
and locks the setting. This should be performed whenever a new tank is
installed or as the tank level decreases.
Argon bottle connection and pressure gauge
