Instruction manual
SPEEDLINER 8050WS - SPEEDLINER 9080WS
Code M0205 - rev.1.0
(11/2010)
BUTLER S.p.A.
BUTLER Engineering & Marketing S.p.A. a s.u. -
Via Balduina 5/7 - 42010 Rio Saliceto (RE - Italy)
Page 27/51
Tel. +39 0522 647911, Fax +39 0522 649760
e-mail: [email protected] / www.butler.it
Figure 30
As for models SPEEDLINER 9080WS, once the position indicator has reached the target
position, screen Figure 29, will be displayed for approx. three seconds, which are enough for
the programme to acquire measurement readings.
As for models SPEEDLINER 8050WS, turn wheel by 240° and, once the target position is
reached, press detector keypad central key, as indicated on the screen Figure 28.
The last phase consists in taking wheel back to the starting point: third point.
Once last rotation (to go back to starting position) has been carried out, programme acquires
the last measurement readings. The screen Figure 29 will be displayed again for approx.
three seconds. After measurement acquisition, programme will automatically continue, and
the following screen will be displayed:
Figure 31
Figure 32
On Figure 31 the front left wheel is shown with a tick on the side, to indicate that the
procedure has been carried out on that wheel. Procedure can anyway be repeated by pressing
again the central key of the concerned detector. When the Run-Out procedure has been
completed on all wheels, programme will automatically go to the next phase.
Position
indicator
Rotation
second
target point
Central key
flashing
Wheel on which the
procedure has been
Wheel position has changed
compared to the final point
