Instruction manual
SPEEDLINER 8050WS - SPEEDLINER 9080WS
Code M0205 - rev.1.0
(11/2010)
BUTLER S.p.A.
BUTLER Engineering & Marketing S.p.A. a s.u. -
Via Balduina 5/7 - 42010 Rio Saliceto (RE - Italy)
Page 3/51
Tel. +39 0522 647911, Fax +39 0522 649760
e-mail: [email protected] / www.butler.it
Bluetooth brands are property of their owners, and are used by
BUTLER S.p.A. under license.
0 CAUTION
Any damage caused by failure to follow the instructions in this manual or improper machine
use shall relieve BUTLER S.p.A. of all liability.
0.1 Preliminary Safety Information
Before starting the machine:
Read the instructions and the entire manual before using or working on the wheel aligner.
This manual represents an integral part of the product and is intended to inform the user
on how to use the SPEEDLINER 8050WS and SPEEDLINER 9080WS wheel aligner. Keep
the manual for the entire life of the machine. Keep it in an easy to access place and refer
to it every time the need arises. All machine operators must be able to read the manual.
Make sure the power supply is in conformity with the specifications shown on the plate.
Voltage and frequency data plate is positioned on machine back side. Please, read plate
data. NEVER connect aligner to a voltage or frequency other than the specified ones.
Duly arrange wheel aligner power cable. This product features a 3-wire plug with built-in
grounding. It can be plugged into a socket with built-in grounding, only. Should a
grounded socket not be available for machine connection, contact an electrician. Do not
tamper with or misuse plug.
Upon machine switching off:
Do not switch off the built-in PC by unplugging it or by turning PC switch to off, but
follow the procedure set forth in par.4.2 on page 14. PC wrong switching off could lead to
HARD-DISK files "corruption".
The switching off procedure set forth in par. 4.2 on page 14 does not affect detector
recharge supports, which continue being powered.
In emergency conditions and before performing any maintenance:
Insulate the machine against any power source using the special master switch, and
remove plug from power socket.
Do not try to service this unit arbitrarily, as the opening or removal of machine doors
could expose user to hazardous voltage. Maintenance operations shall be carried out by
authorised service personnel, only.
Work environment and machine cleaning:
The work environment must be kept clean and dry, and must not be exposed to
atmospheric agents. It must also be well lit.
Do not clean the machine using jets of water and compressed air.
To clean plastic panels or surfaces use a moist cloth (avoid using liquids containing
solvents).
BUTLER S.p.A. shall be entitled to make any changes to the models described in this manual
at any time for reasons of a technical and commercial nature.
