INSTRUCTION, USE AND
MAINTENANCE MANUAL
EN
Page 47 of 96
12.4 Use of the adhesive roll weights (stand-
ard on some models)
This device allows you to always have the number of
adhesive weights needed in order to balance the wheel.
The grammage of each single weight is normally equal
to 5 grams.
After the first balancing phase, when the program high-
lights the weight to be applied to the wheel, simply re-
move the necessary number of weights (
1
) to reach the
quantity required by the machine and, using scissors
or a suitable cutting device (
2
), separate the desired
quantity (
1
) from the roll, as shown in the figure below.
TO PREVENT THE ROLL WEIGHTS
FROM SLIPPING OUT OF THEIR
SUPPORT (3) AFTER CUTTING,
MAKE SURE TO ALWAYS LET
A SUFFICIENT NUMBER OF
WEIGHTS (4) (AT LEAST 7-10
WEIGHTS) PROTRUDE FROM THE
SUPPORT ITSELF, AS SHOWN IN
THE FIGURE.
These weights must be manually detached from their
plasticized support and applied to the wheel as indi-
cated in the specific paragraph.
13.0 DISPLAY WITH KEYBOARD
The wheel balancers are equipped with a control panel
equipped with a keyboard to interact/operate the con-
trols presented in graphical form on the monitor.
On the monitor are displayed all the instructions for the
correct wheel balancing, for example indicating where
the operator shall fit adhesive or clip weights and the
balancing mode and/or option used, as well as correct
wheel rotation for inner/outer weights positioning.
Fig. 39
KEY
1 – Monitor
2 – Function push button (red)
3 – Function push button (yellow)
4 – Function push button (grey)
5 – Function push button (blue)
6 – Function push button (green)
7 – Previous page push button
8 – Next page/print push button
9 – Push button panel (keyboard with 7 keys)
1301-M001-02
LIBRAK360S - LIBRAK360PS - LIBRAK360WS - LIBRAK360PWS - LIBRAK360WSON - LIBRAK360PWSON - LIBRAK360PWSPRO - LIBRAK360PWS-MC - LIBRAK360PWS-OPEL