I
Page 38 of 96
INSTRUCTION, USE AND
MAINTENANCE MANUAL
EN
INSTRUCTION, USE AND
MAINTENANCE MANUAL
9.2.13 TEq-Link service configuration (stand-
ard on some models)
The wheel balancers must be connected to the work-
shop's WIFI network. It is possible to set up the WIFI
by searching for WIFI networks, through a service PC.
ATTENTION: AT THE END OF THE
CONNECTION TO THE WORKSHOP
WIFI, CHECK THE ACTUAL CON-
NECTION BY MAKING SURE THAT
THE GREEN "LINK" LED (SEE FIG-
URE BELOW) LIGHTS UP ON THE
RS232/WIFI CONVERTER INSIDE
THE KIT.
It is sufficient that the PC itself has access to WI-FI and
an Internet Browser.
Follow the instructions below to set up the WIFI.
- Connect the PC to the default WiFi SSID of the RS232/
WiFi converter device: “
USR-W610_****
”
THE LAST 4 CHARACTERS ARE
DIFFERENT FOR EACH DEVICE.
ALWAYS CHECK FOR
✓
ON “CON-
NECT AUTOMATICALLY” BEFORE
CLICKING ON THE “CONNECT”
BUTTON.
IF THE “USR-W610_****” WIFI
NETWORK IS NOT FOUND, IT MAY
BE NECESSARY TO "RESET" THE
RS232/WIFI CONVERTER DEVICE
(USRW610) INSIDE THE KIT. THE
RESET BUTTON IS LOCATED UN-
DER THE ANTENNA CONNECTOR
(SEE FIGURE BELOW)
Press and hold for at least 10 sec.
with a pointed object to reset the USR-
W610 device
- Type the URL in the address bar of the Internet
Browser:
10.10.100.254
when the authentication
window appears, enter ID
→
admin
and Password
→
admin
.
LIBRAK360S - LIBRAK360PS - LIBRAK360WS - LIBRAK360PWS - LIBRAK360WSON - LIBRAK360PWSON - LIBRAK360PWSPRO - LIBRAK360PWS-MC - LIBRAK360PWS-OPEL
1301-M001-02
LIBRAK360S - LIBRAK360PS - LIBRAK360WS - LIBRAK360PWS - LIBRAK360WSON - LIBRAK360PWSON - LIBRAK360PWSPRO - LIBRAK360PWS-MC - LIBRAK360PWS-OPEL
