_
5
_
Assembly
Loop Handle Installation
1. Place the loop handle and the bottom clamp on the shaft
approximately 28cm (11 inches) from the end of the stop
switch/ throttle trigger assembly.
2. Install the four screws and nuts. Tighten the screws evenly.
3. Reposition the loop handle up or down the shaft assembly
to the most comfortable position, but no closer than 23 cm
(9 inches) from the end of the stop switch/throttle trigger
assembly.
4. Tighten the screws and nuts.
Connecting Throttle Cable
1. With air filter cover removed, Put two cable adjuster
nuts (packed with Engine Box) on the end of throttle
cable. Slip the throttle cable through the slot in the
slotted fitting, making sure the cable lug drops into the
recessed hole (See sketch).
2. Position the throttle cable in the throttle cable bracket
fix it with tightening the two cable adjuster nuts. Adjust
the cable position to keep 1-2mm play between cable
lug and slotted fitting (See sketch).
3. Operate the throttle trigger a few times to make sure
that it works correctly. Check the stop on the carbure-
tor throttle cam just contacts the idle speed adjustment
screw when the throttle trigger is fully depressed.
4. When the throttle cable is adjusted correctly, tighten
two cable adjuster nuts.
Assembling Engine and Shaft Assembly
Attach the clutch drum housing to the engine using the four
screws supplied with the unit.
Bottom Clamp
Shaft Assembly
Nut (4)
Loop Handle
Screw
(
4
)
Engine
Screw (4)
Clutch Drum Housing
Cable Lug
Recessed Hole
Slotted Fitting
1-2mm
Play
Shaft Assembly