![background image](http://html.mh-extra.com/html/bushranger/mc-e-2/mc-e-2_owners-and-operators-manual_2835584008.webp)
_
7
_
MC-T-2 (Cultivator Attachment)
Installing Shaft and Gearcase
Attach the shaft assembly to the gearcase assembly.
NOTE: Carefully inspect both side of the shaft
assembly. The arrow marking side of the shaft
assembly positions to the power unit. The no
marking side of the shaft assembly connects
to the gearcase assembly.
Insert the shaft assembly into the gearcase
assembly while rotating the driveshaft to
engage the splines. Align the locating hole
and install the locating screw through the
side of the gearcase. Then tighten the
clamping screw. If properly installed, rotating
the end of the driveshaft will cause the
cultivator tines to move.
Installing Shaft Assembly and Guard
Place the plastic collar onto the shaft assembly
approximately 2,5cm from the cultivator gearcase,
locating the ends as shown in sketch. Then place the
two bracket parts onto the plastic collar and fasten
securely with two 6 mm screws. Attach the guard to
the bracket with four 5 mm screws.
Screw 6mm(2)
Bracket
2,5cm
Plastic Collar
Bracket
Screw 5mm(4)
Guard
Bracket
Gearcase
Locating Hole
Shaft Assembly
Arrow Mark
Driveshaft
Gearcase
Splines
Clamping Screw
Locating Screw
Attaching and Detaching for the Power
Unit and the Shaft Assembly
Attaching
1 First, loosen the clamping knob before
attaching the shaft assembly to the shaft cou-
pler.
Note: Do not over loosen the clamping
knob or it may fall out.
Clamping
Knob
Shaft Coupler
Positioning
Lever
Positioning Hole
Shaft
Assembly
Insert
Tighten
Loosen
Summary of Contents for MC-E-2
Page 15: ......
Page 16: ...P N 241976 00 GB 1905 IN 11 Sodium Street Narangba Qld 4504 ...