Bushranger MC-E-2, Owner'S And Operator'S Manual

Page: 3 / 16

＿
2
＿
Operator safety
1. Read and understand this Manual before using the Multi-Cutter.
Be thoroughly familiar with the proper use of this Multi-Cutter.
2. Always wear eye protection and hearing protection.
3. Always wear heavy long pants, a long sleeved shirt, boots and gloves. Do not wear loose clothing,
jewelry, short pants, sandals, or go barefoot. Secure hair so it is above shoulder length.
4. Never operate this Multi-Cutter when you are tired, ill, or under the influence of alcohol, drugs or
medication.
5. Never start or run the engine inside a closed room or building. Breathing exhaust fumes can cause
death.
6. Keep the grip of handles clean of oil, fuel and dirt.
Multi-Cutter safety
1. Make sure the Multi-Cutter is assembled correctly and that the tool attachment is correctly installed
and securely fastened as instructed in the Assembly section beginning on page 6.
2. Inspect the Multi-Cutter before each use. Replace damaged parts. Check for fuel leaks. Make sure all
fasteners are in place and tightened securely. Follow the Maintenance instructions beginning on page 11.
3. Shut off the engine and be certain the attached tool has completely stopped moving before inverting
the Multi-Cutter, performing maintenance on or working on the machine.
4. Make sure the attached tool does not move at engine idle speed. Refer to Idle Speed Adjustment,
page 8.
5. Inspect the tool attachment and replace any parts that are cracked, chipped or damaged before using
the Multi-Cutter.
6. Never use a tool attachment or replacement parts that are not approved by BUSHRANGER.
7. Maintain the Multi-Cutter according to the recommended maintenance intervals and procedures in the
Maintenance section beginning on page 11.
8. If running problems or excessive vibration occur, stop immediately and inspect the unit for the cause.
If the cause cannot be determined or is beyond your ability to correct, return the Multi-Cutter to your
servicing BUSHRANGER dealer for repair.
Safety Instructions
The warning system in This manual identifies potential hazards and has special safety messages that help
you and others avoid personal injury, even death.
, and are signal words to identify the level of hazard.
: signals an extreme hazard that will cause serious injury or death if the recommended
precautions are not followed.
: signals a hazard that may cause serious injury or death if the recommended precautions
are not followed.
: signals a hazard that may cause minor or moderate injury if the recommended precau-
tions are not followed. Two other words are also used to highlight information. “Important”
calls attention to special mechanical information and “Note” emphasizes general informa-
tion worthy of special attention.