Bushranger MC-E-2, Owner'S And Operator'S Manual

Page: 11 / 16

＿
10
＿
Guard
Knob
Wheel
Increase the
Depth of Cut
Decrease the
Depth of Cut
Setting Depth of Cut
IMPORTANT: Set the depth of cut before you start the engine.
1. Loosen the knob holding the guard to the plate.
2. Rotate the guard as necessary to set the depth of cut.
Note that:
・ Rotating the guard to raise the wheel increases the depth of cut.
・ Rotating the guard to lower the wheel decreases the depth of cut.
3. Make sure the guard is positioned to protect the operator from
thrown debris, then tighten the knob.
MC-T-2 (Cultivator Attachment)
Operating Position
Before using the Multi-Cutter with Cultivator Attachment, check the following:
1. The unit may be on operator’s right side. The operator’s right hand should be holding the shaft grip, with
his or her fingers on the throttle trigger. The right arm should be slightly bent.
2. The left hand should be holding the loop handle with the fingers and thumb fully enclosed around the
grip. The left arm should be extended. Reposition the loop handle up or down the shaft assembly if
necessary for a comfortable position.
3. Do not operate the unit in hard un-tilled soil or in rocky areas.
4. Do not operate the unit in areas with vines or tree roots.
5. Do not operate the unit in water.
6. Always release the throttle trigger and allow the engine to return to idle speed when not cultivating.
7. Stop the engine when moving between work sites.
・ The unit should be operated only while traveling forward. Working the
unit with a back-and-forth motion while traveling produces the best
results.
A fast or slow engine speed can be used according to soil conditions.
・ If the Cultivator tines becomes jammed, stop the engine immediately.
Make certain all moving parts have stopped and disconnect the spark
plug before attempting to remove any obstruction.
・ The cultivator gearcase becomes very hot during operation. Do not
touch the gearcase.
・ Make certain all moving parts have stopped and disconnect the spark
plug before inspecting the equipment for damage.
・
Never use a unit that has cracked or broken tines.
Cultivator Motion
Direction of Travel
CAUTION
・
Read the Safety instructions beginning on page 2 concerning proper use of the Multi-Cutter.
CAUTION
・ Always wear gloves and protective clothing when operating the Multi-Cutter with Cultivator
Attachment.