Bushranger MC-E-2, Owner'S And Operator'S Manual

Page: 13 / 16

＿
12
＿
General Cleaning and Tightening
The BUSHRANGER Multi-Cutter will provide maximum performance for many, many hours if it is main-
tained properly. Good maintenance includes regular checking of all fasteners for correct tightness, and
cleaning the entire machine.
WARNING
POTENTIAL HAZARD
・
When engine is running, attached tool and other parts are moving.
WHAT CAN HAPPEN
・ Contact with moving tool or other moving parts could cause serious personal injury or death.
HOW TO AVOID THE HAZARD
・
Always turn off your Multi-Cutter before you clean or perform any maintenance on it.
Storage
Please see your Multi-Cutter Power Unit Owner’s/Operator’s Manual.
1. Perform all regular maintenance procedures and any repairs.
2. Store the Multi-cutter in a dry place away from excessive heat, sparks or open flame.
Troubleshooting
Problem Cause Action
Engine will not start
・ STOP switch set to off position
・ Empty fuel tank
・ Primer bulb wasn’t pushed enough
・ Engine flooded
・ Move switch to on position
・ Fill fuel tank
・ Press primer bulb until fuel flows
through the fuel return line
・ Use warm engine starting procedure
Engine will not Idle ・ Idle speed set incorrectly ・ Set Idle speed
Engine lacks power or stalls
when cutting
・ Throttle wire has come loose
・ Dirty air filter
・ Tighten throttle wire
・ Clean or replace air filter
If further assistance is required, contact your local authorized BUSHRANGER service dealer.