Bushranger MC-E-2, Owner'S And Operator'S Manual

Page: 12 / 16

＿
11
＿
Maintenance
MC-E-2 (Edger Attachment)
Flexible Drive Shaft
Maintenance Interval
The Edger Attachment uses a flexible drive shaft inside the
drive shaft tube. The flexible drive shaft should be lubricated
after each 30 hours of use.
Flexible Drive Shaft Lubrication
1. Loosen the two screws holding the gearcase to the drive
shaft tube and carefully remove the gearcase from the
drive shaft tube.
2. Grip the end of the flexible drive shaft and remove it from
the drive shaft tube.
3. Lubricate the flexible drive shaft with a high quality #2
lithium-base bearing lube (P/N 211337).
4. Reinstall the flexible drive shaft into the drive shaft tube.
Twist the flexible drive shaft as you insert it into the to en -
sure that it seats into the clutch drum.
5. Reinstall the gearcase onto the drive shaft tube, then
tighten the two screws.
Gearcase
Maintenance Interval
The gearcase lubricant should be inspected for after every 30
hours of use.
Gearcase Maintenance
Remove the blade and the boss adapter. Clean any dirt and
debris from the area between the boss adapter and the gear-
case. Remove the gearcase plug from the side of the gear-
case. While rotating the attaching shaft, inject lithium-base
bearing lube (P/N 211337) through the plug hole until the
gearcase is full. Re-install the gearcase plug.
Bearing Lube
(P/N.211337)
Bearing Lube
(P/N.211337)
Gearcase
Flexible Drive Shaft
Drive shaft Tube
Screw
Gearcase
Attaching Shaft
Boss Adapter
Grease Plug
Plug Hole
Lubrication
Maintenance Interval
The Cultivator gearcase should be inspect after each 25
hours of use.
Lubrication
The Cultivator gearcase holds 40g of lubricant. A grease fit-
ting is located in the top of the gearcase. Lubricant should be
checked at least every 25 hours of operation. Use a #2 lithi -
um-based lubricant with Molybdenum additive.
MC-T-2 (Cultivator Attachment)
Grease Fitting