Bush Hog DHP10, Operator'S Manual

Page: 31 / 68

ASSEMBLY
DHP8, DHP10, DHP12 05/21 Assembly Section 3-7
© 2021 Alamo Group Inc.
A
SS
EM
B
LY
Disc Gang Positioning
The harrow disc gangs are designed to be
adjustable to fit your specific environment and
application. The following is a good stating point to
achieve the best cutting results. Depending on soil
type and hardness a wider or narrower gang spread
may be needed.
1. Align the front gangs as close together as
possible without touching or binding in the
middle. Approximately three inches from the
gang tube edge to the gang hanger edge is a
good starting point. Fine tune each side until
the gangs are almost touching and spin freely.
2. The rear gang disc should line up in between
the cutting edges of the front disc. To
accomplish this, measure six to ten inches from
gang tube to gang hanger. Tighten U-Bolts and
nylocks to the correct torque.
OPTIONAL SCRAPER KITS ASSEMBLY
Scraper kits are sold as an option and can be added at any time. Each kit comes with two different scraper
assemblies. Type A is used for left front and right rear. Type B is used on the right front and left rear.
1. Bolt one attachment plate to each gang hanger using the 5/8”x4-1/2” U-Bolts (1) and 5/8” nylocks (2)
supplied with the harrow.