Bush Hog DHP10, Operator'S Manual

Page: 32 / 68

ASSEMBLY
DHP8, DHP10, DHP12 05/21 Assembly Section 3-8
© 2021 Alamo Group Inc.
A
SS
EM
B
LY
2. Mount one of the square tubes (3) to the attachment plates on each of the disc gangs using the 3/8”x1-5/8”
U-Bolts (4) and 3/” nylocks (5) supplied with scraper kit. The square tubes are th same and can be
mounted on any of the disc gangs. Center the tube leaving approximately the same distance on either side
of the outer attachment plates.
Snug the nuts only.
Do not fully tighten the nuts because some adjustment
may be needed.
3. Refer to the drawing to identify the “A” and “B” type scraper assemblies. Attach type “A” to the left front and
right rear disc gangs using the 3/8”c1-5/8” U-Bolts (4) and 3/8” nylocks (5). The type “A” scraper assembly
should be mounted a few inches away from each disc and slant inward toward the concaved side of the
disc. The scraper should be close to the disc but does not have to touch to be affective. Snug the nuts.
4. Refer to the drawing to identify the “A” and “B” type scraper assemblies. Attach type “B” to the right front
and left rear disc gangs using the 3/8”x 1-5/8” U-Bolts (4) and 3/8” nylocks (5). The type “B” scraper
assembly should be mounted a few inches away from each disc and slant inward toward the concaved
side of the disc. Snug the nuts. The scraper should be close to the disc but does not have to touch to be
effective.
5. Once you have all the scrapers in their approximate place, tighten the nuts that secure the square tube to
the attachment plate.Fine tune each scraper’s position and tighten to the proper torque.
6. Check the tightness of the scrapers before each use.
OPTIONAL CENTER SWEEP ASSEMBLY
1. Mount the center sweep weldment (1) to the
middle frame tube using the attachment plate,
1/2”x5” capscrews and 58” nylocks. The center
sweep should be as close to the front gangs as
possible for best results.
2. Fasten the C tine (3) to the center sweep
weldment (1) using a 1/2”x1-1/2” capscrew and
1/2” nylocks.
3. Mount the plow point (4) to the C tine (3) using
two 3/8”x1-1/2” plow bolts and two 3/8” nylocks.