Page 45 of 82
Date: 27.01.06
6.13.2
Options
Advanced options are displayed for the test measurement if you click on the
"Options" button.
Display
The graphical display of the upper and lower limit values and the minimum and
maximum values during the test measurement can be enabled/disabled here.
This information is displayed by dashed lines in the graph.
Device settings
You can define here whether to retain or discard at the end of the test
measurement any limit values changed during the test measurement.
Measurement
Here you can set for the test measurement the read period for the measured
values and the time window displayed in the graphical display.
You can also switch between displaying the graphs as a "continuous trace" or a
"complete cycle".
Start trigger settings – Limit values
A threshold (limit) value on the X or Y axis can be defined as a start trigger.
Recording of measurements only starts after this threshold value is reached.
Start trigger settings – Start time
A start time for the measurement can be set in the form of a date and time, but
make sure that this time does not lie in the past.
When the start time is reached, measurement recording starts.
The current time is shown in the lower part of the dialog window when the Start-
time trigger is enabled.
Stop trigger settings – Limit values
A threshold (limit) value on the X or Y axis can be defined as a stop trigger.
Measurement recording is stopped when this threshold value is reached.
