VI. Maintenance
Grease the wheel-pivot assembly twice a year (monthly under
wet, dirty, salty conditions). Use a standard grease gun with multi-
purpose (thick brown, or green) grease and insert into the hole
on pivot casing (1). Wipe clean all the old grease that fl ushes out.
This can be done while you wait by your local bike shop or gas
station.
Inspect handle, receivers, parking brake and wheel pivot monthly.
Replace any loose or damaged parts.
Burley Walk n’ Roller Limited Warranty
Burley will repair or replace any Walk n’ Roller parts it determines to be defective for
the life of the trailer. The owner of a Burley trailer with Walk n’ Roller parts installed
must present the trailer for repair at an authorized Burley dealer, together with
an original sales receipt or similar proof of purchase. This warranty applies to the
original owner and is non-transferable. Burley cannot be responsible for failure
due to improper assembly, modifi cation of parts or instructions, neglect, abuse,
accident, and/or normal wear. The warranty does not cover any trailers used for
rental, competition, or commercial use, nor does it cover Walk n’ Roller parts used
on anything other than a Burley trailer.
Burley neither assumes nor authorizes any person to assume any other liability in
connection with Burley trailers, and there are no oral agreements or warranties
collateral to or affecting this agreement.
This warranty gives you specifi c legal rights. You may also have other rights which
vary from state to state.
Burley Design Cooperative
4020 Stewart Road • Eugene, Oregon 97402 USA
(541) 687-1644 • Fax (541) 687-0436
www.burley.com
Copyright © 2004 by Burley Design Cooperative
“Burley” is a registered trademark of Burley Design Cooperative
Burley Solo is a trademark of Burley Design Cooperative
1
rev. 04/04
