UŽÍVATEĽSKY MANUÁL MIEŠAČA - MODEL R6167
Strana 23 z 24
8. CARE AND MAINTENANCE
Remove the plug from the socket before carrying out any adjustment, servicing or
maintenance.
Your power tool requires no additional lubrication or maintenance. Always store your power
tool in a dry place.
If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or
similarly qualified persons in order to avoid a hazard.
If a fault can not be rectified, return the mixer to an authorized dealer for repair.
Cleaning
_ Keep the safety devices, ventilation slots and Motor housing as free of dirt and dust as
possible. Clean the unit by rubbing it with a clean cloth or blow it clean using low-pressure
compressed air.
_ We recommend that you always clean the unit immediately after using it.
_ Clean the unit regularly by rubbing it with a damp cloth and a little soft soap. Do not use
cleaners or solvents; these will attack the plastic parts in the unit. You must also ensure that
water cannot get into the inside of the unit.
Carbon brushes
_ If excessive sparking occurs you must have the carbon brushes checked by a qualified
electrician.
Attention! Only a qualified electrician is allowed to change the brushes.
Maintenance
_ There are no parts fitted inside the unit that require maintenance.
9. CORRECTIVE ACTION IN CASE OF FAILURE
(1) The operating switch is switched on, but the motor is not working.
-- Wires in the mains plug or in the socket are loose.
Have socket and plug checked or repaired.
-- The switch is faulty.
Have the switch replaced.
(2) The operating switch is switched on, but unusual noises can be heard, the motor is not
working or only very slowly.
-- Switch contact has failed.
Have the switch replaced.
-- Component jammed.
Have the electric tool checked or repaired.
-- Too much thrust, as a result the motor is dragging.
Use less thrust during the task.
(3) Motor gets hot.
-- Foreign substances have got inside the motor.
