Burley 4111-R, Installation, Servicing & User Instructions

Page: 15 / 28

14
8.0 COMPLETE THE ASSEMBLY
8.1 Fuel Bed Arrangement
It is important for clean burning that the fuel bed components are correctly located as
detailed. Do not use with incorrectly fitted, broken, or any other fuel bed components than those
supplied with the product.
8.1.1 Carefully place the rear (largest) log piece on
the support platform behind the burner. Ensure the
base of the log piece is flat on the support and that the
rear is pushed back as far as possible. Ensure that no
part of this log piece is in contact with the tubular
burner (Fig.8).
Figure 8
8.1.2 Carefully place the front log piece on the
support platform in front of the
burner. Ensure
that the base of this piece is flat and slowly push back
until it touches the protruding ends of the rear log
piece (Fig. 9)
Figure 9
8.1.3 Using photo to identify the correct ‘Y’
shaped log, place log on the left hand side of the
fuel bed to bridge the front and rear logs. The ’V’ of
the log should rest towards the centre of the fuel
bed with one branch located in the notch of the
rear log whilst the other branch rests on the front
log. The other end of this log should be touching
both front and rear logs and the left hand side
cheek (Fig. 10)
Figure 10
8.1.4 Place the remaining log to the right
hand side of the fuel bed to bridge the front
and rear log pieces. The stubby branch should
nestle down and be located in the notch on
the right of the rear log piece. The other end
of the log shall come to rest on the branch
stub protruding from the front log piece,
whilst also touching the rear log piece (Fig. 11)
Figure 11