10
PRE-TURBO MOUNT:
1. Drill a 5/16” hole into the exhaust manifold where all the exhaust runners of the manifold come together
just before the turbo exhaust inlet. Then tap the hole with a 1/8: pipe tap and mount the pyrometer probe
in the hole. Use 9/16” wrench to tighten the probe holder or tube fi tting to the down tube. Then tighten the pyro
probe cap to the holder using a 5/8” wrench.
2. Run the pyro cable along the brim of the engine bay so the end meets the end of the OutLook Main Har-
ness and use zip ties to secure the line.
3.Connect the Pyrometer to the OutLook Main Harness: if you want Pre-Turbo temperatures displayed in the bot-
tom left quadrant on the Outllook screen connect the Pre-Turbo pyrometer connectors to Pyro 1 connectors on
the OutLook Main Harness. Connect the shorter wire from the pyrometer to the longer wire on the OutLook Main
Harness labeled pyro 1 using a set of pliers and a screw driver. Connect the longer wire from the pyrometer to the
shorter wire coming off the OutLook Main Harness labeled pyro 1.
4. If a second pyro is not used then connect the remaining pyro 2 wires to the long black ground wire that is stick-
ing out from the Main Harness using the existing hardware. This will ensure that there is no electrical interference
between the Pyro connections. To further protect the connections wrap all of the pyrometer connections in electri-
cal tape.
Summary of Contents for GM DURAMAX 6.6L 2001-2006
Page 1: ...INSTALLATION MANUAL GMDURAMAX6 6L2001 2006 Part 40366v1 0 0...
Page 22: ...21 Monitor...
Page 23: ...22...
