Bully Dog GM DURAMAX 6.6L 2001-2006, Installation Manual

Page: 10 / 24

9
Monitor
POST TURBO MOUNT:
1. Find a location on the exhaust pipe that is 3-6” downstream from the turbo charge output. Then drill a 5/16” hole
and run a 1/8” pipe tap into the hole. Mount the pyrometer probe in the hole , use a 9/16” wrench to tighten the
probe holder or tube fi tting to the down tube. Then tighten the pyro probe cap to the holder using a 5/8” wrench.
2. Run the pyro cable along the brim of the engine bay so the end meets the end of the OutLook Main Har-
ness and use zip ties to secure the line.
3. Connect the Pyrometer end to the OutLook Main Harness: if you want post turbo temperatures displayed in
the bottom left quadrant on the Outllook screen connect the post turbo connectors to the Pyro 1 connectors on
the OutLook Main Harness. Connect the shorter wire from the pyrometer to the longer wire on the OutLook Main
Harness labeled pyro 1 using a set of pliers and a screw driver. Connect the longer wire from the pyrometer to the
shorter wire coming off the OutLook Main Harness labeled pyro 1.
4. If a second pyro is not used then connect the remaining pyro 2 wires to the long black ground wire that is stick-
ing out from the Main Harness using the existing hardware. This will ensure that there is no electrical interference
between the Pyro connections. To further protect the connections wrap all of the pyrometer connections in electri-
cal tape.