Bully Dog GM DURAMAX 6.6L 2001-2006, Installation Manual

Page: 8 / 24

7
Monitor
INSTALLING THE OUTLOOK MAIN HARNESS:
In this step you will run the OutLook harness plugs and wiring through the fi rewall and
connect the Main Harness to the Sub-Harness and the OBD 2 Harness.
1. For a clean install fi rst peel back the weather stripping on the
driver’s side door seal right next to the dash and down.
See the
OutLook Mounting options available to determine how you
will mount the OutLook before completing this step; this
will save you the trouble of installing the OutLook twice if
you are using an A-Pillar mount.
2. Set the OutLook Monitor up on the driver’s side dash and run the
OutLook wires down behind the dash to conceal the wiring Remove
the side dash panel to assist in running the wiring. Reinstall the side
dash panel and the weather stripping.
3. Run the end of the OutLook wiring harness through the fi rewall
into the engine bay. Use the same hole as done with the OBD 2 Har-
ness. Pull all of the slack from the cab through the fi rewall.
4. Connect the green plug (male) on the end of the OBD 2 Harness to
the green plug (female) on the OutLook Main Harness.
5. Connect the green plug (female) on the end of the Sub-Harness
to the green plug (male) on the OutLook Main Harness.
Omit step
5 for installs on all 2006 ve-
hicles.
6. Go inside the cab of the vehicle
to test the install before going
any further. Turn the ignition to
the run position, the OutLook at
this point should light up and
display a vehicle selection screen.
7. Secure all wiring to ensure that
wiring is safe from extreme heat
and moving parts using zip ties
provided. (save two zip ties for
the pyrometer)
2006 wiring will NOT have a Sub-Harness connection