40
(940) 783-9915
|
www.bullydog.com
TUNING VEHICLE
PREPARING FOR TUNING INSTALLATION
– JEEP VEHICLES ONLY –
In order to enjoy additional power and other advantages of tuning your vehicle, you need to
use the Install Download feature. The process is basically the same when you are installing,
changing settings, or returning to stock.
CAUTION! THIS OPTION ACTIVELY REPROGRAMS THE ENGINE COMPUTER IN YOUR VEHICLE
– IF THE PROCESS IS INTERRUPTED YOU MAY HAVE PROBLEMS WHICH COULD PREVENT
YOU FROM USING THE GT GAS OR EVEN BEING ABLE TO DRIVE YOUR VEHICLE FOR A FEW
DAYS. IN ORDER TO HAVE THE BEST INSTALLATION EXPERIENCE POSSIBLE, REVIEW THE
INSTRUCTIONS AND PAY CLOSE ATTENTION TO THE PREPARATION STEPS LISTED BELOW.
Internet Access
During installation process, you will need to connect
the GT to the Internet using a home computer or
laptop with a Windows® operating system.
Update the GT Gas
Use the Update Agent to update the GT. See page 21
for those steps
Allow time for initial setup
Make sure you allow up to one hour to complete the
tuning installation process.
Check fuses (GM Vehicles Only)
Check the included Check Fuse Card that was included
in the GT Gas packaging and remove the appropriate
fuses before installing the tune. (Replace the fuses
after the download is complete.)
Check your battery
Before installation, ALWAYS ensure that the batteries
are fully charged. If you are not sure, connect a
battery charger before you begin installing the tune.
Turn electronics OFF
Leaving electronics on may prevent a successful
download. Electronics include: headlights, heater,
air conditioning, stereo, DVD players, or anything
plugged into electrical outlets in the vehicle. Also be
sure to disconnect any aftermarket electronic device
such as Trailer brakes, stereo, alarm, CB, remote start,
Sirius/XM satellite radio, etc.
Make sure tune is intact
Go to the Main Menu on the GT Gas and choose the
Show Settings option and check what is showing next
to Download
If the GT Gas shows Installed connect the GT Gas
to the original vehicle and uninstall the tune. If this
cannot be done, contact technical support for a reset
– there may be a fee for this service.
If the GT Gas shows "Not Installed" you can continue
with your preparations to install the download to
your vehicle. If the GT Gas shows "Recovery", contact
technical support for further assistance.
IMPORTANT NOTE: It is not recommended
to use the GT Gas with any other electronic
tuner designed to increase horsepower.
