Bull NovaScale T840, User Manual

Page: 68 / 302

User Guide
68
www.bull.com
Selecting Server Site
To use the server, install it on a standard EIA 19-inch rack assembly.
Refer to the documentation attached to the rack or contact your sales agent for the
installation of the server on the rack.
Warning
Observe the following instructions to use the server safely. Failure to
follow these instructions may result in death or serious personal injury.
See
“General Safety Information” on page 138
for details.
■
Do not use the server in any unapproved place.
■
Do not connect the ground line to a gas pipe.
Caution
Observe the following instructions to use the server safely. Failure to
follow these instructions may cause a fire, personal injury, or property
damage. See
“General Safety Information” on page 138
for
details.
■
Do not carry or install the server only by a single person.
■
Do not install the server where the load may be concen-
trated on a specific point.
■
Do not install any component on the server only by a single
person.
■
Do not pull out a device from the rack if the rack is unstable.
■
Do not leave more than one device being pulled out from the
rack.
■
Do not provide the wiring exceeding the rating power.
Do not install the rack in the places listed below. Installing the rack or mounting the
server on the rack in such a place may cause some malfunction to occur.
■
Narrow space from which devices cannot be pulled out from the rack completely
■
Place that cannot bear the total weights of the rack and devices mounted on the
rack
■
Place where stabilizers cannot be installed or where the rack can be installed only
after the practice of proper earthquake-resistant construction
■
Place of uneven or slanting floor
■
Place of drastic temperature change (near a heater, air conditioner, or refrigerator)