Bull NovaScale R440 E1, User Manual, Page: 163 / 366

User Guide
162
www.bull.com
SAS hard disk drive
Can be used only when one of the optional RAID Controller listed below is installed:
- LSILogic MegaRAID SAS 8480E Controller
- Disk Array Controller (SAS/SATA HW RAID0/1)
- Disk Array Controller (SAS/SATA HW RAID5/6)
Up to three hard disk drives (mounted on the dedicated 3.5-inch width tray) can be
installed.
Caution
Do not use any hard disks that are not approved by your sales
representative. Installing a third-party hard disk may cause a
failure of the server as well as the hard disk. Purchase hard
disks of the following models:
- 36.3 GB, 15000 rpm, SAS
- 73.2 GB, 15000 rpm, SAS
- 146.5 GB, 15000 rpm, SAS
- 300 GB, 15000 rpm, SAS
Figure 99: SAS hard disk drive bays
The hard disk drive bays are connected to the Mini SAS connector on the motherboard.
To use the hard disk drives in a RAID System, refer to:
■
When using the Onboard RAID Controller (LSI Embedded MegaRAID):
Use LSI Software RAID Configuration Utility or Universal RAID Utility to build,
configure, and manage the RAID System.
■
When using an optional RAID Controller:
Use WebBIOS or Universal RAID Utility to build, configure, and manage the
RAID System.
Port 0 Port 1 Port 2