Bulex Thema Condens AS 48-A, Manual, Page: 149 / 199

MAKSİCONDENSE 48-65
Notes
03/2020 143 T
EKNİK EĞİTİM VE DESTEK
6.3.4.2 Target flow value for heating mode (limitation)
This parameter allows the required flow temperature to be set (first display level)
This setting also limits a higher temperature demand from the control.
6.3.4.3 Target domestic hot water temperature (limitation)
– first display level
This parameter allows the required domestic hot water temperature to be set in connection with a
domestic hot water cylinder. A cylinder sensor must be installed for this purpose.
The domestic hot water charging output can be limited under
D.077 by kW value.
That is used to adapt the output in dhw to the HEX of the dhw cylinder.
6.3.4.4 Maximum heat output
The maximum unit output can be restricted in this parameter ( D.071 )
6.3.4.5 Additional relay factory delivery
(D.026) Definition of the actuator connected to connection terminal X16 (OPT).
6.3.4.6 Optional 2 in 7 accessory relay
(D.027; D.028) Definition of the actuator connected to relay 1 of the 2 in 7 module (VR 40).
6.3.5 Checking the gas setting
6.3.5.1 Checking the factory settings
You must check whether the gas type set at the factory corresponds to the local gas type. The factory
settings can be found on the data plate.
6.3.5.2 Checking the tightness of the flue gas system and recirculation
1. The flue gas system must comply with the certification
2. Check supply air. There must not be any flue gas measured in the annular gap
If flue gas is measured in the supply air and the flue gas system leak cannot be
eliminated, the unit must not be started up.