9
“Flux recovery vacuum” switch (S2)
Turns on the power of the vacuum for flux recovery.
Inverter ON/OFF “Lighting switch”
Push button switches to power on / off the inverter. Switch on the hurricane lamp for night operation.
CAUTION: Switching the inverter on and off in Emergency stop short interval could cause damage to
the inverter. It is not recommended to switch on the inverter again for at least three minutes after is it
turned off.
“Lighting switch”
Switch on the hurricane lamp for night operation.
Emergency Stop
Push button stops all electronic functions including welding and travel.
Slave Control (for BGWII double sided model ONLY)
Used at the slave side of the double sided girth welder, it is basically the same as the master control, but without
the function to control the drive system.
