Buffalo TeraStation WS5200DN2, User Manual

Page: 7 / 109

Switches between the different display modes. Also, if the TeraStation is beeping, press this button to stop it.
8
Factory Use Only
9
Drive Lock
Open the front panel with the key to replace hard drives or press the reset button.
10
Reset Button
To shut down and reboot the TeraStation, hold down the reset button.
11
Status LEDs
Normally, these LEDs blink green when hard drives are accessed. If a drive fails, its LED will turn red.
12
VGA Connector
You can connect a VGA monitor to this port. Connecting a monitor directly to the TeraStation is only supported
for monitoring the progress of Windows Update.
13
Boot Mode Switch
Leave the switch on the "HDD" position during normal operation. To recover settings, insert the recovery USB
drive into a USB 3.0 or 2.0 port, move the boot switch to the "USB" position, and press the power button.
14
UPS Port
Connect to a UPS.
15
USB 3.0 Port
Compatible Buffalo USB 3.0 hard drives, USB memory devices, digital cameras, and USB UPSs can be
connected. USB hubs are not supported.
16
USB 2.0 Port
Compatible Buffalo USB hard drives, USB memory devices, digital cameras, and USB UPSs can be connected.
USB hubs are not supported.
17
LAN Port 1
Use an Ethernet cable to connect this port to your network.
18
LAN Port 2
This second Ethernet port may be used for network redundancy or backup. You may connect a second
TeraStation directly to this port for backup.
19
Power Connector
Use the included power cable to connect to an UPS, surge protector, or outlet.
20
Fan
Do not block the fan.
21
Anti-Theft Security Slot
Use this slot to secure your TeraStation with a cable lock (not included).
22
UID Button
Press the UID button on the front or the back of the unit to cycle the blue LED on and off.
23
Serial Number
This sticker shows the TeraStation's serial number.
24
Link LED
6