Buffalo TeraStation WS5200DN2, User Manual

Page: 101 / 109

LCD Message Description Corrective Action
HDx Error E16
HDx Not Found
Unable to find hard drive X.
Hard drive X may be disconnected or may
have failed. After shutting down, reinstall the
hard drive.
HDx Broken E30
Replace the DISK An error occurred, so hard drive X
was removed from the RAID array.
Replace hard drive X.
SYSTEM I10
TOO HOT !
A rise in the system temperature
may have exceeded the allowable
safety value. Move the TeraStation to a cool location. Do
not place objects in the area around the
TeraStation.
Operation I12
DEGRADE MODE
Operating in degraded mode.
Check the drive where the error occurred
and replace it with a new hard drive. For
replacing method, refer to the "Hard Drive
Replacement Procedure" section in chapter 5.
RAID I18
X Drive Rebuilding
Rebuilding drive X in the array.
Note:
Transfer speeds are slower
during the rebuilding process.
Wait until the RAID resynchronization
finishes. It will take about 8–12 hours per
terabyte for a RAID 5 volume and 3–6 hours
per terabyte for a mirrored volume. This
message will disappear when the RAID
resynchronization finishes.
Replication I33
Replicate Failure An error occurred during
replication.
From Buffalo Replication, click Sync to
execute resynchronization. If the error is
displayed again, contact Buffalo technical
support for assistance.
New Firmware I52
Available A new firmware version has been
released.
Update the firmware.
I54
Backup Failure
A backup job has failed.
Make sure that the backup job is configured
correctly, and that the NAS is on and not in
standby mode. If the backup job still fails,
check the status of NAS, the network, and the
backup source and destination. Also, check
the backup log to see if any errors were
recorded.
Default Settings
Administrator's Name Administrator
Password password
Shared Folders
Drives C and D are configured as administrative hidden shares
by Windows Storage Server's default settings.
DHCP Client
Normally, the TeraStation will get its IP address automatically
from a DHCP server on the network. If no DHCP server is
available, then an IP address will be assigned as follows:
IP Address: IP address will be assigned starting from "169.254".
Subnet Mask: 255.255.0.0
Registered Groups Windows Storage Server's default groups are registered.
Microsoft Network Group Setting WORKGROUP
RAID Mode
Drive C: A mirrored array using drives 1 and 2
Drive D: A RAID 5 array using all drives
*
* WS5200DN2 and WS5200DR2: Drive D is a mirrored array using
drives 1 and 2.
100