Buell 2005 P3, Service Manual, Page: 70 / 426

2005 Buell P3: Maintenance 1-21
HOME
TRANSMISSION/PRIMARY FLUID 1.11
GENERAL
Transmission fluid capacity is 1.0 quart (0.95 liter). For best
results, drain fluid while it is hot.
INSPECTION
1. Remove seat. See 2.28 SEAT.
1 1
WARNING
1
WARNING
To prevent accidental vehicle start-up, which could
cause death or serious injury, disconnect negative (-)
battery cable before proceeding. (00048a)
2. Disconnect negative battery cable from battery.
3. Remove left footpeg support bracket. See 2.21 FOOT-
PEGS AND FOOTPEG SUPPORT BRACKETS.
4. See Figure 1-15. Remove three TORX screws with
washers (1) from clutch inspection cover (2). Remove
clutch inspection cover from primary cover.
5. See Figure 1-16. Inspect fluid level with motorcycle in
upright position.
6. See Figure 1-15. Install clutch inspection cover using
three TORX screws with washers. Tighten in a crosswise
pattern to 84-108 in-lbs (9.5-12.2 Nm).
7. Install left footpeg support bracket. See 2.21 FOOT-
PEGS AND FOOTPEG SUPPORT BRACKETS .
8. Connect negative battery cable to battery. See 1.5 BAT-
TERY .
1 1
WARNING
1
WARNING
After installing seat, pull upward on front of seat to be
sure it is in locked position. While riding, a loose seat can
shift causing loss of control, which could result in death
or serious injury. (00070a)
9. Install seat. See 2.28 SEAT .
Figure 1-15. Primary Cover
7667
1. Torx screws with washers (3)
2. Clutch inspection cover
3. Magnetic drain plug (with o-ring)
1
2
3
Figure 1-16. Fluid Level
1. Adjusting screw
2. Cable end
3. Coupling
4. Correct fluid level
a0126x6x
1
3
2
4